As far as game aids go, there are two schools of thought. Some players show up a tape measure, some dice, and an attitude, while others rely on a full toolbox of equipment. I am among the latter, being Type A and a little on the spectrum. In my continued effort to answer questions you never asked, I designed this movement tool .stl.“But why?”Well, while shooting generally involves straight lines, movement – particularly for infantry units – adds literal twists and turns. Can that infantry section make a complete run to enter a building/bunker/get behind heavy cover?You could use a metal tape, but it is difficult to get multiple bends out of it, and if it springs back, it will sweep everything before across their table.This .stl pack is a simple print, which snaps together. You can make it into whatever length you are seeking (12” in the case of the print pictured). It stands upright and can create a serpentine path to illustrate your movement route. “But I don’t have room in my gaming box for more stuff?”Bosh! This model folds up into itself and takes up about 1” x 1”.Besty of all, it’s a free file. Printing GuideThis will print in either FDM or resin.It will require you to press the connector (the small piece) into the protruding nubs of the larger piece. It’s a tight fit but it does fit. I used the end of a wooden spoon to do so.