Here you can see it in action:
https://youtu.be/9Cofmy4bZX4

Uh...didn't find a way to attach a package with .stl files. Here they are:
https://drive.google.com/open?id=1hNs4ZOr_H-nXIlVeMiUy7iY9UJ5GkodB

Made with Fusion 360. A toy car with double-acting 1-cylinder compressed air engine (like the steam locomotives have). Has steering, which even works. I call it "vapemobile" because of the remote shape).

Apart from these printed parts, you'll need some extra ones to assemble it:

* 623ZZ bearing (4x10mm, 3mm hole) (may poorly work without it)
* Piece of 1.75mm filament
* Rubber band
* Thin plastic bag
* 6mm silicon pipe (can be found in any aquarium shop)
* 4mm pipe from intravenous dropper (or any that you could pull onto the syringe end)
* Two 2ml syringes
* 8mm piece of 4mm PTFE tube (optional)
* Air balloon
* Bolts: M3x6 x8, M3x8 x8, M3x10 x3, M3x12 x5, M3x14, M3x25, M3x50
* M3 washers x10
* M3 nuts x30

3d Printable Pneumatic-Engined Toy Car

This model is a remix of K1 rear right bracket side cutout.(https://www.printables.com/model/910436-k1-rear-right-bracket-side-cutout) Diameter of the hole is decreased for ptfe tube If you've enjoyed my work and would like to buy me a coffee to support my creative efforts, you can do so through the link below. Your generosity is greatly appreciated! Buy Me a Coffee: https://www.buymeacoffee.com/ahmetutkuozkan

K1C Rear Right bracket remix

Instead of reducing the free movement of the IFS tubing to the extruder caused by the enclosure, this mod allows for the almost original clearance of the PTFE tubing. In my opinion reducing the strain on the extruder assembly. At the same time this will seal the open air gap from the original slot on the enclosure. -Basic design.-Modified models C4 and D4 from the official (new taller version) AD5X enclosure.-The slotted acrylic panel is replaced by 2 printable panels. Printing notes:-For printing the hood i used tree supports and reduced the acceleration speeds by 10x to improve on some corner overhangs. Instructions:-After printing all 5 models replace models C4 and D4 from the original enclosure with the new ones.-Slide down the Acrylicleft + Acrylicright panels replacing the original slotted acrylic panel.-Slide down the Hood with the PTFE tubes inside.-Put back the top of the AD5X enclosure. -The original unmodified enclosure file is also included as backup. 03-28-2026 - Initial release (replacing the older version completely as this can be used by anyone who uses the taller ad5x enclosure)

Flashforge AD5X Enclosure Mod - Large PTFE pass-through

Cantilever PTFE Tubing Cutter

Asset Library

About These Assets