(Note: The original file names are in Turkish. "Mi box yükseltici" translates to "Mi Box Riser".) Take your setup to the next level with the V2 Anti-Slip Mi Box Riser! Based on the original design, this upgraded version features a 4mm deep recess at the bottom. This allows you to attach felt pads (keçe) to ensure the stand stays firmly in place and never scratches your desk or TV unit. What's new in V2? * Surface Protection: Integrated 4mm pocket for felt or rubber pads. Max Stability: Perfect for glass or slippery wooden surfaces.(If you want a faster, simpler print without the felt pocket, check out the V1 Standard version in my profile). File Formats:I have included STL, 3MF, and STEP files so you can print it immediately or easily remix and adjust the dimensions to fit your specific needs. Files Included: Mi box yükseltici v2.3mfMi box yükseltici v2.STEPMi box yükseltici v2.STL Print & Test Details: Test Print: Approximately 54 minutes. Use the included "Test" plate in the 3MF file to check the footprint.Full Print: Approximately 1 hour and 41 minutes. Recommended Print Settings (Optimized): Layer Height: 0.20 mmWall Loops: 3Bottom Shell Layers: 5Infill Density: 3% (Gyroid)Supports: NoMaterial: PLA If you've enjoyed my work and would like to buy me a coffee to support my creative efforts, you can do so through the link below. Your generosity is greatly appreciated!Buy Me a Coffee: https://www.buymeacoffee.com/ahmetutkuozkan