## Scanning The scans were captured with wireless connection to my workstation to capture the data faster (~80FPS over WiFi). For the laser scan marker tracking was used. The scan bench was placed on a turntable with marker geometries placed around it to allow scanning from shallower angles (as seen in last picture). The resolution was set to 0.1mm and exposure was adjusted so the white print wasn't overexposed. For laser mode I used a combination of cross, parallel and single line mode, changing them can be done by double pressing the scan start button on the scanner. ## Post-Processing For both scans processing was done using the recommended settings within CrealityScan. This is basically only Fusion since it already generates a mesh at this step which can directly be exported. After exporting the meshes I used Quicksurface to align the meshes to the coordinate system and each other.