## Scanning The motorcycle was scanned in markerless alser mode on the Rigil using 1mm resolution and feature tracking without connection to a PC. For scanning itself I didn't do any preparations like scan spray and focused on the both sides with one scan per side whilst ensuring enough overlap for easy alignment in later steps. While scanning the Rigil held roughly 20 FPS. Scanning itself took roughly 5 to 10min per side, so a a bit longer than in IR mode (was using 1.5mm there though). ## Post-Processing Post processing was done on my workstation and included generation of the point clouds, automatic feature alignment and subsequent meshing in recommended settings. Quicksurface was used for alignment to the coordinate system and reduction of the point cloud size. Since it came out quite large I reduced it to 4M so the scan could be uploaded to Sketchfab.