For laser mode and FullField marker tracking was used. The scan bench was placed on a turntable with marker geometries placed around it to allow scanning from shallower angles (as seen in last picture). The resolution was set to 0.15mm in laser mode and exposure was adjusted so the white print wasn't overexposed. For laser mode I used a combination of cross and single line mode, changing them can be done by first using the "M"-button to select the mode slector and then plus and minus to switch modes. Full-Field mode was done similar to the laser mode with the high accuracy preset and manual exposure. The two other IR modes had to be done in feature tracking since marker tracking is not yet supported in these modes. Both Hybrid and VSCEL were done in the high-accuracy preset without the use of the AI segmentation feature since the stark contrast between black turntable and white part already created a segmentation.